How to Level Samsung Refrigerator [2023]? (Answered)

Sharing is caring!

How to level Samsung refrigerator? When you install a new refrigerator in your kitchen, one of the first things you should do before sliding it into place is to ensure that it is properly balanced with the countertop.

If you skip this step, the performance of the refrigerator may be compromised, and various systems may fail to operate properly.

When leveling a refrigerator, you aren’t seeking for the unit to be absolutely level; rather, you are trying for it to be as level as possible.

In fact, it should be set back a little bit, with the front edge of the refrigerator being higher than the back edge of the refrigerator.

Fortunately, leveling is a simple and straightforward process in the majority of circumstances.

How to Level Samsung Refrigerator
How to Level Samsung Refrigerator

Other Related Articles:

A Guide on How to Reset Your Samsung Refrigerator

Samsung Refrigerator Noise Stops When Door Open

How to Defrost Samsung Ice Maker?

How to Level Samsung Refrigerator

To level a Samsung refrigerator, use a screwdriver to raise that side of the refrigerator by rotating the leveling legs to the left. Repeat on the other side of the refrigerator until it is level. To ensure that it is level from top to bottom and left to right, a carpenter’s level is required.

Why do You need To Level Your Samsung Refrigerator?

If your Samsung refrigerator isn’t level, you could be spending more money on electricity than you need to because of its inefficiency.

Because of the refrigerant, which circulates through the system as a liquid before passing through the evaporative coils and turning into a gas, the system is susceptible to leaks.

The evaporation process necessitates the use of heat, which is provided by the refrigerator section, which is what causes the compartment to be cold.

The refrigerator will not operate properly if it is not level because liquid refrigerant will pool in the coils and will not evaporate, causing the compressor to cycle on more frequently in order to maintain the required temperature.

You will be charged for the additional compressor time on your energy statement.

Legs for leveling a Samsung refrigerator

The leveling procedure, according to Samsung, is a straightforward one that involves only three steps, the first and last of which are so insignificant that they are not included in the final total.

Find the leveling legs, adjust the leveling legs, and make any small changes, according to Samsung instructions.

Recommended:  What is Samsung refrigerator error code 33 E? [2023]

Although Samsung addresses some of the issues that may arise, the company does not address others, such as how to adjust the Samsung refrigerator leveling legs with the weight of the refrigerator on them, how to make “minor adjustments,” and how to determine whether or not your refrigerator is level.

Actually, adjusting the leveling legs and making the final Samsung fridge level adjustment isn’t that difficult, but you’ll need a helping hand or a flat bar to do it – and you’ll also need a spirit level.

Tools that You Need When Leveling Your Samsung Refrigerator

  • A carpenter’s level is necessary to level the refrigerator from top to bottom and from left to right.
  • Turning the legs will require the use of a flat-head screwdriver. (2)
  • A Phillips screwdriver, if a kickplate is required to be removed, will likely be necessary.

7 Steps To Level The Samsung Refrigerator

Step 1: First, gather all of the necessary equipment:

  • It’s necessary to use a carpenter’s level to ensure that the refrigerator is perfectly level.
  • The legs must be turned with the use of a flat-head screwdriver.
    In the event that a kickplate needs to be removed, a Phillips screwdriver may be necessary.

Step 2: Next, look for the leveling legs, which should be underneath the refrigerator at the front of the cabinet.

The refrigerator is supported by two leveling legs that help to keep it level and secure.

There are also four caster wheels on the refrigerator, which are used to move it.

In order to gain easier access to the leveling legs on Side by Side and Four-Door versions, open both doors simultaneously.

A refrigerator’s front leg cover must be removed in order to have access to the leveling legs more easily.

This will vary from model to model since certain coverings do not need to be removed in order to have access to the legs.

If you want to remove the front leg cover, first remove the screws using a Phillips screwdriver, then push it up from the bottom and drag it out of the way.

Illustration of the front leg cover being removed
Look for the leveling legs, which should be underneath the refrigerator

Step 3: Place a flat-head screwdriver into one of the notches on either side of the leveling leg. It makes no difference which one you choose to tweak first.

Step 4: Using the screwdriver as a lever, rotate the leveling leg to the left until it stops.

This will raise the side of the refrigerator that is on that side. Repeat the process on the other side of the refrigerator until it reaches its maximum height.

Illustration of adjusting the leveling leg with a screwdriver
rotate the leveling leg to the left until it stops

Step 5: Using a carpenter’s level, check to see that the refrigerator is level from left to right and from front to back.

Make certain that the main unit, not the doors, is at the proper elevation (which can be adjusted separately).

If the refrigerator is not level, first decide which side is higher than the other, and then move the leveling leg to the right and check the level again on that side.

Continue to make adjustments until the refrigerator is leveled out completely.

Step 6: Also, make sure that the refrigerator is level from front to back, as the refrigerator is supposed to be level and square when installed.

Recommended:  What does UR mean on Samsung washer [2023]

However, if your doors do not remain open when you want them to, you can raise the legs slightly in front of the door to slant it slightly backward.

Step 7: On the majority of flat surfaces, the legs should be stretched to the point where the front wheels rise off the ground.

Step 8: Don’t forget to replace the front leg cover after you’ve finished (if you removed one). Your refrigerator has now been balanced and is ready to use!

Wheels are frequently found on Samsung refrigerators

Home kitchen
Wheels are frequently found on Samsung refrigerators

Moving a Samsung refrigerator around the kitchen floor without damaging the surface is often made possible by wheels or rollers that are built into many of the appliances.

The rear rollers are more durable than the front rollers, and you can normally leave the refrigerator resting on them rather than the front rollers, which is not always the case.

This implies that as long as the Samsung refrigerator wheel locks are set, you won’t have to worry about adjusting the rear feet.

If you ever need to remove or replace either of the refrigerator’s front rollers, simply tilt the refrigerator’s front up and pull the pin on each roller until it falls out.

Installing a new roller is as simple as positioning it between the holders and pressing the pin back into place.


It’s easy to take your refrigerator for granted because it’s always on and working until there’s a problem.

Undoubtedly one of the most messed-up mishaps is discovering water spilling out from under your fridge.

But don’t give up hope!

We’ll go over the most common reasons why your Samsung refrigerator is leaking water, including everything from a malfunctioning filter to a clogged defrost drain.

We’ll also go over the repairs that have been implemented to bring this dependable appliance back to life.

Is it possible that your Samsung refrigerator is leaking?

Here’s What You Should Do

It can be difficult to locate the source of refrigerator leaks, and the leaks themselves can be dangerous because of the potential harm they can do.

When your Samsung refrigerator is leaking water, these typical causes make troubleshooting easier and provide clear solutions, saving you time and money.

The refrigerator is not at the proper level

Improper leveling of a Samsung refrigerator is one of the reasons for water leakage.

In order for a refrigerator to cool properly, the front of the appliance must be somewhat higher than the back, allowing coolant to flow freely.

If the refrigerator is not properly leveled, it will have to work more to maintain its cooling capacity.

This pressure causes further condensation around the condenser coils, which causes water to flow onto the floor.

If your refrigerator was just installed or your floors were recently redone, it is possible that the refrigerator is not level and will need to be adjusted.

The leveling legs of your Samsung refrigerator are located beneath the front panel of the appliance.

Using a screwdriver, move the legs to the left or right until a carpenter’s level certifies that the modifications have been made correctly.

The inside of the water filter is leaking.

If you discover that your refrigerator is leaking water from the inside, it is most likely due to a filter problem.

Recommended:  Kenmore Refrigerator Ice Maker Reset [2023]

Listed below are some of the most prevalent causes of Samsung refrigerators leaking water from their filters:

  • Incorrect installation of the filter
  • The filter head is fractured or damaged.
  • An incorrect fit was caused by a filter brand other than Samsung.
  • The filter housing has cracks in it.
  • If you have filter leaks, use these methods to fix them:

Refer to your refrigerator’s user manual for specific instructions on how to replace the water filter.

1. Examine the filter for damage and, if necessary, replace it with a new one.

2. Only Samsung-branded filters should be used to ensure the correct fit.

3. Professional servicing is required to replace a damaged filter housing.

The refrigerator is leaking water into the Kitchen

Extreme humidity may be to blame for a refrigerator that is leaking water outside.

The presence of moisture in the air on hot and humid days might combine with the water already present in the refrigerator, causing leaks.

When the bottom of your Samsung refrigerator begins to leak, it is because moisture has accumulated in the drain pan and has overflowed into the floor underneath the unit.

When it is humid, emptying the drain pan might aid in the evaporation process and prevent leaks from occurring.

Reduce the temperature of the kitchen with fans or air conditioning, if possible, to reduce the amount of humidity in the air.

Clogged defrost drain in the refrigerator

The most common cause of water in your crisper drawers or water seeping out of your refrigerator onto the floor has to do with a clogged defrost drain in your refrigerator.

The refrigerator’s automatic defrost system features a drain tube that empties any extra water into a drain pan located beneath the refrigerator.

The water usually evaporates once it has been placed in the pan.

If the drain tube becomes clogged, however, water will eventually overflow and cause a leak to occur.

Drain blockages and leaks can be eliminated by following these steps:

Refrigerator drain holes can be reached by removing all objects and shelves from the refrigerator’s interior and exterior walls.

Bake soda and water or bleach and water are both acceptable solutions.

It is also possible to use hot water.

Squirt the solution or hot water into the drain hole with a turkey baster to dislodge the obstruction.

When you hear the water moving down the tube and into the drain pan, this indicates that the clog has been removed.

You should seek expert assistance if you are unable to dislodge the obstruction on your own.

Call Sharper Service Solutions for prompt Samsung refrigerator repair when your refrigerator begins to leak.

Our Final Thoughts

Water leakage difficulties, cooling problems, noise concerns, and refrigerator damage can all be avoided if your refrigerator is properly leveled.

Please see the instructions below on how to adjust the volume.

Frequently Ask Questions

Is it necessary to level a Samsung refrigerator?

Your refrigerator must be level in order to save energy and avoid potential cooling issues, noises, or leaks. This guide will walk you through the process of leveling your fridge and making minor leveling adjustments. Before moving the refrigerator, always raise the leveling legs into the refrigerator and off the floor.

How long does it take for a Samsung refrigerator to settle?

Why are three-way refrigerators required to be level?

Three-way refrigerators, unlike compressor refrigerators, must be level in order to function properly. Even if they are only a few degrees off level, they may not work at all, especially in hot weather.


  • Khelly Perez

    Hi, I'm Khelly! I am your tech expert for all your Samsung Products and Information needs. Life is complicated so, finding solutions to your tech problems shouldn't be. Let me help you with that!

Sharing is caring!

Similar Posts